Search
  • Stretch & Go Compression Belt

Stretch & Go Compression Belt

The Stretch&Go® Belt is designed to help eliminate back pain.

The secret behind the Stretch&Go® Belt is that it features a pump which expands the belt up to 7cm allowing spinal decompression. Once inflated using the small handy pump, the decompression stretches the spine allowing more space between the vertebrae and less pressure on the discs. It also enables the discs to be rehydrated and your nerves released. This will help relieve pain and reduce inflammation.

Stretch&Go® was designed to be worn under clothes without being visible and can be worn day or night. Suitable for men and women


Write a review

    Bad           Good

Stretch & Go Compression Belt

The Stretch&Go® Belt is designed to help eliminate back pain.

The secret behind the Stretch&Go® Belt is that it features a pump which expands the belt up to 7cm allowing spinal decompression. Once inflated using the small handy pump, the decompression stretches the spine allowing more space between the vertebrae and less pressure on the discs. It also enables the discs to be rehydrated and your nerves released. This will help relieve pain and reduce inflammation.

Stretch&Go® was designed to be worn under clothes without being visible and can be worn day or night. Suitable for men and women


Write a review

    Bad           Good

Stretch & Go Compression Belt

SAVE $29.95
Buy 2 Stretch and Go for just $269.95 was $299.90
 
  • Increase space between vertebrae
  • Reduce Pressure
  • Rehydrate disks
  • Eliminate nerve pressure
  • Ease pain and inflammation
 
  • Availability: In Stock




Stretch and Go Back Pain Device
Why stretch and go works

Worn correctly and daily the Stretch&Go® Belt can eliminate the back pain ruining your life. It works on three levels:


  • By decompressing the vertebrae.

  • Allowing the discs to be rehydrated.

  • And releasing the spinal nerves.

Daily Usage


Wear the belt initially for 30-60 minutes, once you are comfortable using the belt then you can extend the time worn each day. It may take a bit of time to get used to. To get maximum benefit wear for at least one hour each day. If you have chronic back pain, use for an hour three to four times a day. Use for at least one month. It is important to be patient and listen to your body, everyone is different, it may take longer to feel the full effects.


1. Place the belt between the lower rib cage and hip, either under your clothes or over tight-fitting clothes.

2. There is a tummy EXTENDER Velcro Strip enclosed if needed to make the belt longer for larger waists. Attach one end of the Stretch&Go® Belt Belt to the EXTENDER then wrap the belt around your waist and attach it to the other end of the EXTENDER. Once securely in place you can then inflate the belt.

How to use stretch and go
Why stretch and go works

3. Secure belt around waist. Straight away your back will feel supported.

Inflating the Belt

To inflate the belt push the valve firmly into the pump and lift up the lever on the back of the pump. The valve should now be secured into place.

5. Inflate the belt using the pump; right away you will start to see it expanding, and you will instantly feel more upright. Do not pump more than 22 times as over-inflating can damage the belt.

6. When inflating do not cover the air hole at the base of the pump as you will not be able to pump it fully.

7. Pumping will expand Stretch&Go® Belt Belt by 7cm, increasing it from 13cm to 20cm, this will allow your spine to decompress. It will help lift your lumbar and unload the weight off your lower back allowing your muscles to relax.

8. Once inflated push down the lever at the back of the pump and pull out the valve; carry on with your day, walking, sitting, even driving.

9. Worn for hours, the Stretch&Go® Belt Belt increases the distance between your vertebrae, allowing your discs to regenerate. It also puts an end to the pinching of the spinal nerve that cause sciatica and lower back pain.

Deflating and removing the belt

10. Deflate the Stretch&Go® Belt Belt by unscrewing the valve. Once the belt is deflated re-tighten the valve. The StretchANDGo® Belt can now be easily removed.

Looking after your Stretch&Go® Belt

Use a damp cloth to clean the belt, do not immerse in water. Keep in a dry, cool place and away from direct heat or sunlight. Only use the pump supplied to inflate the belt. Handle with care and do not drop the pump.

How to inflate stretch and go How to inflate stretch and go
how to fix problems with the belt